Step 2 of 8 · Beginner method

White Cross

Drop each daisy petal down with a double turn to build the white cross — every edge matched with its side centre.

  1. 1The Daisy
  2. 2White Cross
  3. 3First-Layer Corners
  4. 4Second-Layer Edges
  5. 5Yellow Cross
  6. 6Yellow Edges
  7. 7Yellow Corners — Position
  8. 8Yellow Corners — Orient

How to hold the cube

Yellow stays up while you drop the petals. When all four are down, flip the cube over (x2) to check the finished white cross — then flip back.

Each petal must travel down to the white centre AND end up between the right colours. "Matched with its centre" means the petal’s side sticker lines up with the centre of the same colour.

The procedure, per petal: turn only the top (U) until the petal’s side sticker sits directly above the centre of the same colour. Then turn that face twice (F2, R2, B2 or L2) — the petal drops straight down onto the white face, perfectly placed.

Repeat for all four petals. If you always align before dropping, a drop can never disturb an already-dropped edge — each petal has its own face.

When the daisy is gone, the white cross is complete on the bottom. Flip the cube over (x2) and check: every cross edge shows white on top, and its side colour flows straight down into the matching centre.

A white edge whose side colour does NOT match is in the wrong slot: bring it back up with the same double turn, re-align it over the correct centre, and drop it again.

This matching is the foundation of the whole solve — a mis-slotted cross silently breaks every later step. When you are sure, flip back over (white down, yellow up) and keep it that way: from here to the finished cube, you will never flip the cube again.

Watch it happen

See the states

After the flip: white cross done, corners still unsolved — that’s correct
One petal drop: side colour matched over the centre, then a double turn

The algorithms

Petal drop

The petal’s side sticker matches the front centre: F2 sends it home.

Check flip

All four petals dropped: flip the whole cube to inspect the cross, then flip back.

Tips

Common mistakes

← Step 1: The DaisyStep 3: First-Layer Corners